RLL544CP N Gauge 15x Concrete 6 Panel Fencing and Posts

WE CEASE PRODUCTION OF N GAUGE KITS ON 1ST SEPTEMBER

Our 2nd N gauge product added to the Railway Laser Lines portfolio is the pack of 15x (3 strips of 5 panels) N Gauge 6 Panel Concrete sections (these ones are made from our ModelBord along with 16 concrete posts (1mm MDF) that will give you a length of fencing around 240mm, or you can order a twin pack to make up 480mm and save some money.

The panels have six engraved lines horizontally on both sides to respresent singular concrete panels and 5 panels make up each block.

Simply use a sharp modelling knife/zippy blade or equivalent to cut the panels from the template. Do the same for the concrete posts and then slide the panels inside the posts and glue along the vertical lines using a very small amount of glue ( we recommend Deluxe Materials glue) using the dabbing method. Immediately wipe away any excess glue with a small brush. Hold each post in place with you finger/thumb to bond, then release and do the remaining ones. When it comes to joing the two panels together the centre post should be glued half one one side and half on the other to give that perfect join. Add some additional glue to the sides of the ends of each concrete panel. Allow to fully dry. Once completed, these can then be glued to your baseboard. Painting and weathering should be done prior to fitting them down on your board.

We have done a ‘How To….’ video on our larger O scale concrete panels, but the method is the same only you may need to use less paint so not to fill the engraved lines. This video can be viewed by simply clicking on the ‘video’ tab next to ‘description’.

Released:-
V1.0 24th October 22

Product Code: RLL-544-CP6

Dimensions (pack of 3 ): L 280mm x H 13mm (post height)

Materials Used; ModelBord, MDF

Assembly Required: Yes

Additional Parts Required (Not Included With Kit): Comes as a kit and parts will require either priming, painting and/or glueing. A sharp craft knife/zippy blade or similar will be required to remove pieces from part of the kit.
Other items required to assist: Deluxe Materials Glue (or equivalent) Sandpaper/file, Primer Paint (optional), Acrylic/Enamel Paint, Paint Brushes.

Advise: When priming/painting, do so in a well-ventilated area and use an appropriate mask. These items are very fragile so handling with care is paramount.

PLEASE NOTE: ALL laser cut kits are made ‘to order’ and current turn around time is 7-10 days, unless we have made any surplus kits, then they will be made readily available. Check below if we have any in stock ready to post out.

NB: PLEASE NOTE – POSTAGE COSTS APPLY ONLY TO WITHIN THE UK – USE OUR CONTACT FORM TO GET A QUOTE OUTSIDE OF THE UK